How much does mini split repair cost?
Every visit starts with a $59 service call, included in the repair price if you approve the repair. Our 2026 mini split repairs started at $500 for a refrigerant recharge and test. The final price is set after the diagnostic.
We repair ductless mini splits of all brands, single-zone and multi-zone, including systems another company installed.
Mini split repair prices
The prices below are what we charge in the East Bay and Marin County.
| Job | Price |
|---|---|
| Service call (included in the repair price if you approve the repair) | $59 |
| Refrigerant recharge and test | From $500 |
| Reconnecting a disconnected system (refrigerant recovery, nitrogen pressure test, vacuum, recharge) | From $1,800 |
| New single-zone mini split (one indoor unit) | From $3,100 |
| New multi-zone mini split | From $7,200 |
What changes the price
- Which part failed. A wired controller is a small job; a leak that means opening the line set is not.
- Refrigerant. How much the system needs, and whether the leak has to be found and fixed first.
- Access to the indoor unit. On a 2025 job in Alamo we had to open drywall to reach the drain line.
- Number of indoor units on a multi-zone system.
Common mini split problems and what we check
What each symptom usually points to, and a recent job where we saw it.
Water dripping from the indoor unit
Usually a blocked condensate drain line or a failed drain pump. The water has nowhere to go and overflows from the indoor unit.
Alamo, 2025: we opened the drywall, removed the indoor unit, ran a new drain line, and installed and wired a condensate pump. $1,900.
Weak heating or cooling
Often low refrigerant. A mini split is a sealed system, so low refrigerant means a leak somewhere: a flare connection, the coil or the line set.
San Rafael (Terra Linda), 2026: a recently installed Ductless Aire unit needed a refrigerant recharge and test. $500.
Unit ignores the remote or wall controller
A failed controller or damaged control wiring between the controller and the indoor unit.
Walnut Creek, 2025: a Mitsubishi unit stopped responding to its thermostat. We replaced it with a Mitsubishi PAR-40MAAU wired controller and ran new shielded low-voltage cable. $635.
Blinking lights or an error code
The unit’s self-diagnostic is reporting a fault. The code tells the technician where to start, but which part failed is confirmed by testing, not by the code alone.
Unit moved or disconnected
Once a line set has been opened (a remodel, a moved unit, a damaged pipe), the refrigerant has to be recovered and the system pressure-tested, vacuumed and recharged before it runs again.
Richmond, 2026: we recovered the R-410A, reconnected the line set at the indoor and outdoor units, pressure-tested with nitrogen, pulled a vacuum and recharged 2.3 lb of refrigerant. $1,800.
A smell from a new unit
New equipment can smell for a while. We check that nothing is wrong with the unit before you live with it.
Oakland, 2026: a new mini split smelled when cooling. We found no fault and recommended running it in different modes to see whether the smell also comes in heating mode. Service call only.
Repair or replace?
The diagnostic tells you what failed and what the repair costs. If it shows a problem that makes replacement the better choice, you know before you pay for parts, and the estimate for a new system is free.
Oakland, 2026 · replaced
An LG multi-split from 2006 had a chronic R-410A leak that couldn’t be located, and a previous technician had added leak sealant to the system. Instead of another recharge, we replaced it with a Daikin three-zone heat pump: $13,297.
New mini splits start at $3,100 for a single zone and $7,200 for multi-zone. Ductless mini split installation →
A recent repair
A mini split that’s been disconnected can’t just be screwed back together. On the Richmond job we recovered the old refrigerant first, reconnected both ends of the line set, held it under nitrogen to check for leaks, pulled a vacuum and put back the measured 2.3 lb of R-410A. Skipping the pressure test or the vacuum is how leaks and moisture end up in a system.
Fuse Service technician
Warranty
Our work comes with a 3-year labor warranty. On an older system we can’t warranty the original components, such as the compressor or a fan motor, because they can fail on their own at any time.
When we’re not the right call
- Ducted heat pumps. A heat pump that heats through ducts is covered on heat pump repair.
- Central air conditioning. See AC repair.
- Air-to-water heat pumps. We don’t work on them.
Mini split repair questions
How much does mini split repair cost?
Every visit starts with a $59 service call, included in the repair price if you approve the repair. Our 2026 mini split repairs started at $500 for a refrigerant recharge and test. The final price is set after the diagnostic.
Which mini split brands do you repair?
All brands. Recent repairs include Mitsubishi, LG and Ductless Aire units. Most mini splits we install are Daikin.
Why is water dripping from my mini split?
Usually the condensate drain line is blocked or the drain pump has failed, so water backs up inside the indoor unit until it overflows. Turn the unit off to limit the damage and book a service call.
Do you repair a mini split another company installed?
Yes. If you think the installation itself is the problem, see bad HVAC installation repair.
Is the repair covered by a warranty?
Our work comes with a 3-year labor warranty. On an older system we can’t warranty the original components, such as the compressor or a fan motor, because they can fail on their own at any time.
Can you come the same day?
Same-day appointments are sometimes available, depending on the technicians’ schedule. We work every day from 5am to 7pm.
Serving the East Bay and Marin County: Alameda, Contra Costa and Marin counties. See the full service area →
Mini split dripping, blinking or blowing warm air?
Service call is only $59, credited to the repair if you approve it.